Part level (p. 108), Part pan (p. 108), Part reverb send (p. 108) – Roland X-6 User Manual
Page 108: Part chorus send (p. 108), Output assign (p. 108), F2 (output effect), 108 creating a performance
108
Creating a Performance
Part Level
Adjust the volume of each part. This setting’s main purpose is to
adjust the volume balance between parts.
Value:
0–127
Part Pan
Adjust the pan of each part. “L64” is far left, “0” is center, and “63R”
is far right.
Value:
L64–0–63R
[F2 (Output Effect)]
fig.09-002_50
For details on these settings, refer to
Part Output Assign
Specifies for each part how the direct sound will be output.
Value
MFX:
Output in stereo through multi-effects. You can also
apply chorus or reverb to the sound that passes through
multi-effects.
A, B:
Output to the OUTPUT A (MIX) jack or OUTPUT B jack
in stereo without passing through multi-effects.
1–4:
Output to the INDIVIDUAL 1–4 jacks in mono without
passing through multi-effects.
PAT:
The part’s output destination is determined by the
settings of the patch or rhythm set assigned to the part.
If you've made settings so that sounds are separately routed to
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plug
is actually inserted in the INDIVIDUAL 2 jack, the sounds
routed to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixed
and output from the INDIVIDUAL 1 jack.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 230).
If you've set Tone Out Assign to “MFX,” set the MFX Output
Assign parameter to specify the output destination of the sound
that has passed through the multi-effects.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the
chorus is set with the Chorus Output Select (p. 209) and the
Chorus Output Assign (p. 209).
• The output destination of the signal after passing through the
reverb is set with the Reverb Output Assign (p. 209).
Part Output MFX Select (Part Output Multi-
Effects Select)
Of the three types of multi-effects that can be used simultaneously,
specify which multi-effects will be used.
Value:
1–3 (MFX-1–MFX-3)
Part Output Level
Set the level of the signal that is sent to the output destination
specified by Part Output Assign.
Value:
0–127
Part Chorus Send Level
Sets the level of the signal sent to chorus for each part.
Value:
0–127
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value:
0–127
MFX1–3 Source
Chorus Source
Reverb Source
The settings of a specific patch can be used as the settings for MFX1
(1)–MFX3 (3), chorus (C), and reverb (R). This setting specifies the
part to which this patch has been assigned.
If no part is selected, the settings of the Performance will be used.
For the following parameters, settings can be made individually
for each multi-effects (MFX1–MFX3) selected in Part Output
MFX Select.
Fantom-X678_r_e.book 108 ページ ２００７年３月２０日 火曜日 午前１０時２０分