Making chorus settings (chorus), P. 215), 215 adding effects – Roland X-6 User Manual
Page 215
215
Adding Effects
Here’s how to specify how MFX 1–3 will be connected.
*
This parameter is not found in Patch mode.
fig.22-010_50
For details on these settings, refer to
Structure Type
Specify how MFX1–3 will be connected.
Value:
Type 01–Type 16
MFX1–3 TYPE
Selects the multi-effect type of MFX1–3.
Value:
0 (Through)–78
Here we will explain how to make chorus settings in Performance
mode. The procedure is the same when making settings in Patch
mode.
fig.22-011_50
For details on these settings, refer to
Type (Chorus Type)
Selects either chorus or delay.
Value
0 OFF:
Neither chorus or delay is used.
1 CHORUS:
Chorus is used.
2 DELAY:
Delay is used.
3 GM2 CHORUS:
General MIDI 2 chorus
*
In this setting screen, you can edit the parameters of the chorus/delay
that is selected by the Chorus Type setting. For details on the
parameters that can be edited, refer to
If a number (
–
) is shown for a parameter in the screen, you
can use the corresponding Realtime Control knob (far left knob
is
– far right knob is
) to adjust the value of that parameter.
When you enter the Chorus screen, the indicator at the right of
the Realtime Control knobs will go out, and the Realtime
Control knobs can be used to edit the Chorus parameters. If you
once again press the button located at the right of the Realtime
Control knobs so the indicator is lit, the knobs will control their
original functions. When you exit the Chorus screen, the
indicator will automatically return to its previous lit state.
Specifying the multi-effect
structure (MFX Structure)
Making Chorus Settings
(Chorus)
Fantom-X678_r_e.book 215 ページ ２００７年３月２０日 火曜日 午前１０時２０分