Roland V-Synth GT - Manual (Page 233)

233
Utility Mode
Perform this adjustment if the D Beam controller is functioning incorrectly, such as responding even though you have
not operated it.
1. In the Utility Menu screen, touch .
The Calibration screen appears.
fig.09-30-ps.eps_50
2. Touch .
The D Beam Calibration screen appears.
fig.09-33-ps.eps_50, fig.09-39.eps
When you place your hand over the D Beam controller, the “L” or “R” level meter in the screen will move upward
or downward.
3. First specify the location at which the D Beam controller will begin responding (i.e., the minimum value).
Move your hand toward the D Beam controller, and touch at the point where you want the controller to
begin responding.
4. Next specify the location at which the D Beam controller will reach the peak (i.e., the maximum value).
Continue moving your hand toward the D Beam controller, and touch at the point where you want the
peak response to occur.
5. While watching the level meter in the screen, raise and lower your hand to check the response of the D Beam
controller.
6. If you are satisfied with the response, touch .
The sensitivity of the D Beam controller will be calibrated.
Adjusting the Sensitivity of the D Beam Controller
V-Synth-GT_e.book 233 ページ ２００７年４月９日 月曜日 午後１時４６分