Renesas M3028BT-EPB - Manual (Page 37)

M3028BT-EPB User’s Manual 2. Setup
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
2.9.5 Connecting to a 85-pin 0.65mm pitch Foot Pattern
Here following is a procedure of connecting to an 85-pin 0.65mm pitch foot pattern on the user system with the M30280T-
85LGF (included with the M3028BT-EPB-5), and here following is its procedure. For details on the M30280T-85LGF, refer to
its user's manual.
(1) Attach the CSSOCKET085B1007RE01 included with the M30280T-85LGF to the user system.
(2) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT-EPB.
(3) Attach the M30280T-85LGF to the CSSOCKET085B1007RE01.
85-pin 0.65mm pitch
No. A1 pin
User system
MCU
CSSOCKET085B1007RE01
(*)
LSPACK
(not included)
These corners are not round.
M30290T-PTCB
M30280T-85LGF
(1)
(2)
(3)
LSPACK085B1007RE01(＊)
Top cover (＊)
Spacer (＊)
M3028BT-EPB
●: A1 pin
*: This product is included with the M30280T-85LGF package.
＊ : These three products are available in one package.
Connecting tools
On-board evaluation with actual MCUs
(PTLG0085JB-A) foot pattern
Figure 2.12 Connecting to an 85-pin 0.65mm pitch foot pattern
CAUTION
Note on Connecting the User System:
z Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator
and user system.
IMPORTANT
Notes on Connectors of the Converter Board:
z The connectors of the M3028BT-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
z The connectors of the M30280T-85LGF and CSSOCKET085B1007RE01 are guaranteed for only 100
insertion/removal iterations.
Page 35 of 86