Roland RD-300 - Manual (Page 43)

45
Making Detailed Settings for the ONE TOUCH Tones
Parameter Value Description
HF Damp 16–15000 Hz, BYPASS
Frequency at which the high-
frequency content of the resonant
sound will be cut (BYPASS: no cut)
LF Damp Freq BYPASS, 16–15000 Hz
Frequency at which the low-
frequency content of the resonant
sound will be cut (BYPASS: no cut)
Lid 1–7
Adjusts the extent to which the lid
of the grand piano is open.
Level 0–127 Output Level
P-Sft Amount 0–127 Amount of fluctuations.
P-Sft Level 0–127 Volume of fluctuations.
P-Sft LPF 16–15000 Hz, BYPASS
Center frequency of filter used to
cut the high-frequency portions
of the fluctuations. (BYPASS: no
cut)
P-Sft HPF BYPASS, 16–15000 Hz
Center frequency of filter used to
cut the low-frequency portions of
the fluctuations. (BYPASS: no cut)
P-Sft to Rev 0–127
Amount by which the fluctuations
are made to resonate further.
Damper offset 0–64
Volume of additional slight
resonance when the damper
pedal is not pressed
Restore the Settings to Initial Conditions
This restores the One Touch Piano settings to their initial conditions.
1. In step 3 of “Making Detailed Settings for the Piano Tones”
(p . 42), choose “5 . Initialize” and press the [ENTER] button .
The Initialize Screen appears.
To cancel the Initialize, press the [EXIT/SHIFT] button.
2. Press the [ENTER] button .
The confirmation message appears.
To cancel the procedure, press the [EXIT/SHIFT] button.
3. Press the [ENTER] button once again .
The [PIANO] button’s tones are initialized.