Roland RD-300 - Manual (Page 15)

17
Getting Ready
Turning the Power On and Off
NOTE
Once the connections have been completed (p. 15), turn on power to your various devices in the order specifi ed. By turning on devices in the wrong
order, you risk causing malfunction and/or damage to speakers and other devices.
Turning On the Power
1. Before you turn on the power, use the [VOLUME] slider to minimize the volume .
Also completely turn down the volume of any connected audio device and other equipment.
2. Press the [POWER] Switch on the back of the RD-300NX to turn on the power .
The unit is powered up, and the display’s backlighting comes on.
ON
OFF
NOTE
• To prevent incorrect functioning of the Pitch Bend/Modulation Lever (p. 33), refrain from touching the lever while the power to the RD-300NX is
turned on.
• This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.
• Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear
some sound when the power is switched on, but this is normal, and does not indicate a malfunction.
• In the unlikely event the power is turned off or cut off while Factory Reset (p. 76) is in progress, the data may become corrupted, and it may require
additional time for the unit to start up the next time.
3. Turn on the power to connected external devices .
4. Adjust the volume of the connected external devices .
5. Adjust the RD-300NX’s volume .
Turning Off the Power
1. Before you switch on the power, turn the volume down all the way by moving the [VOLUME] slider .
Also completely turn down the volume of any connected audio device and other equipment.
2. Turn off the power to connected external devices .
3. Press the [POWER] Switch on the back of the RD-300NX .
The power is switched off .
941
942
943