Nortel Networks NN46110-602 - Manual (Page 63)

Chapter 3 Administrative tasks 63
Nortel VPN Router Troubleshooting
5 Type 5 ( Create A User Control Tunnel (IPsec) Profile ).
6 Enter the user ID that you plan to use to log in remotely to the VPN Router.
7 Enter the password that you plan to use.
8 Enter the password again.
9 When you are prompted for an IP address, you can enter a static IP address
that is assigned to the user during the control tunnel connection. If an address
pool is configured, you do not need to enter a static IP address.
Go to the next section, “Creating a recovery diskette” on page 63 .
Creating a recovery diskette
Before you upgrade the VPN Router, create a recovery diskette. You must
perform this task on the VPN Router itself. To create a recovery diskette:
1 Insert a blank diskette into the floppy drive.
2 Select Admin > Recovery and click Create Diskette.
Backing up system files
Before you upgrade, verify that a recent automatic backup was done in one of the
following methods:
1 If you are located at a remote site, connect to the VPN Router through a tunnel
(branch office or user control).
2 Select Admin > Auto Backup and ensure that a recent automatic backup was
performed to an FTP server.
3 If a recent backup does not exist, use the following steps to create the backup
on the Automatic Backup window:
a Enter an IP address or host name, path, interval, FTP user ID, and
password.
Note: If you have a diskless system, for example, a VPN Router 1100,
the recovery image is stored in flash memory.