Nlynx ETU400 User Manual
Page 255

ETU400 User Guide 011603
E-17
PROBLEM
CPF5149: I/O error detected in XLATIN. Using 36 commands. Customer has to end the
procedure that creates the file to be transferred before it will transfer successfully.
CAUSE:
Need detailed printing of joblog using dspjoblog command. Prompt with F4 and change output to
*print to get details. Look for sharing errors or errors with subfile. Problem typically occurs in S36
mode. This is not an ETU problem but a system problem. 
SOLUTION:
Make certain that the system defaults for the CRTPF have not been modified *NO for sharing.
PROBLEM
“CPF5035 Data mapping error on member XX”.
CAUSE:
A data mapping error occurred on field &4 in record number &5, record format &7, member number
&8, in member &1 file &2 in library &3, because of error code &6. The error codes and their
meanings follow: 
 1 -- There is data in a decimal field that is not valid. 
 
 2 -- A significant digit was truncated. 
 
 3 -- A floating point value exceeded the maximum representable value. 
 
 4 -- A floating-point value was less than the minimum representable value. 
 5 -- A floating point value that is not a number could not be mapped from double to single
 precision or from single to double precision. 
 
 6 -- A floating point value could not be mapped to packed decimal, zoned decimal, or binary. 
 
 8 -- A floating-point value that is not a number is not allowed as a key value. 
 
 9 -- Division by zero. 
 
 10 -- A partial binary key field could not be mapped. The length of the key did not include the 
 entire binary field. 
 
 11 -- A partial key field could not be mapped. The length of the key did not include the entire 
 binary, floating point, date, or timestamp field. 
 12 -- There is data in a DBCS field that is not valid. 
 
 13 -- Group by results could not be determined because no records were selected. 
 
 14 -- The length of a variable length field is not valid or the data in a substring variable is not 
 valid. 
 15 -- A date value is greater than the maximum allowed value. 
 
 16 -- A date value is less than the minimum allowed value.
