Nlynx ETU400 - Manual (Page 172)

ETU400 User Guide 011603 10-42
SBMBATXFER Command
Parameter description Parameter name Parameter values
Command name to submit SBMCMDNAME ETU command name
Job name JOBNAME *JOBD
submitted job name
Job description JOBD *USERPRF
job description name
Library name *LIBL
library name
Job queue JOBQ QBATCH
Job queue name
Library name *LIBL
library name
Display status message? DSPSTSMSG *NO or *YES
The SBMBATXFER command submits the ETU power commands (PCFROMPC, PCTOPC,
PWRFROM3XB, and PWRTO3XB) to batch.
SBMCMDNAM The name of the ETU command you want to submit to batch.
Enter PCFROMPC, PCTOPC, PWRFROM3XB, or PWRTO3XB.
JOBNAME The name of the job you are submitting to batch. The default,
*JOBD, assigns the name of the job description from the
user's AS/400 user profile. You can specify any name up to
ten characters.
JOBD The job description. The default, *USRPRF, uses the job
description associated with the user's AS/400 profile.
Library name The name of the library containing the job
description. The default, *LIBL, searches all
libraries in the user's library list.
JOBQ The name of the AS/400 job queue to which the command will be
sent. The default, QBATCH, is an IBM-supplied job queue.
Library name The name of the library containing the job queue.
The default, *LIBL, searches all libraries in the
user's library list.
HOLD Specifies whether the job will be held or not once it is
placed on the job queue. The default is *NO. To hold the job,
enter *YES. You must then manually release the job.
NOTE: If you are submitting one of the ETU power commands to batch, you
must change the default value, *REQUESTER, in the power command to the
actual device address you will use.