Nortel Networks ICS 6.1 User Manual

Page 98

P0603536 02

Modular ICS 6.1 Programming Record

••• Auto privacy

Select whether a line will be private to the individual on a call, or whether it
can be shared by other users while a call is in progress. The Privacy setting
can be suspended for individual calls using the privacy feature (

²¡Ü

••• Trunk mode

Select whether the line operates with disconnect supervision. Auto answer
and DISA lines must be supervised. This setting does not appear for target
lines.

••• Ans mode

Select whether the line will be answered manually, the normal call answering
method, or automatically by the system. Auto answer allows remote access
to your Norstar system. This setting only appears if Trunk mode is
supervised.

••• Ans with DISA

Select whether a line programmed for auto answer will be answered with
Direct Inward System Access (DISA) or with system dial tone. This setting
only appears if Ans mode is Auto. This setting does not appear for target
lines.

••• Link time

Select the duration of a signal, such as recall or flash, when a signal is
required to access a feature through a remote system.

••• Link at CO

Select whether the system applies the restrictions on outgoing calls to the
digits dialed after the Link signal (a host signalling option).

••• Aux. ringer

Select whether an auxiliary ringer, if installed, will ring for incoming calls on
this specific line.

••• Full AutoHold

Select whether an idle line will be put on hold when another line is selected.
This setting does not appear for target lines.

••• Distinct Ring

Choose whether the line will have a distinctive ring pattern.

••• LossPkg

Select the appropriate loss/gain and impedance package for analog loop
lines only. Select the package based on the terminating switch type (PBX or
CO), and the distance from the switch (Short, Medium or Long). This setting
only appears if Cd1-KSU is Loop. It does not appear for target lines.

••• Rec’d #

Enter the Received number for this target line. When the system
automatically answers an incoming call on auto-answer Loopstart or digital
lines:

• it collects the number of digits specified by the Rec’d # length setting
• it matches these digits to a Received number
• it routes the call to the appropriate target line.

A Received number cannot be the same as, or be the start digits, of a line pool
access code, a destination code, the DISA DN, or the Auto DN.

••• Signal

Select the signal type for an E&M or DID line to match the signal type
programmed for the trunk at the other switch.

••• ANI number

Select whether the telephone number of the caller will be collected for this
E&M or DID line. The digits can then be displayed on Norstar telephones as
part of Call Information services.

••• DNIS number

Select whether the digits dialed by an external caller on this E&M or DID line
will be collected.

••• Gain

Select the appropriate gain level for this E&M or DID line.

•• Name

Enter a name for a line that is up to seven characters long. This name defaults
to the line number.

•• Restrictions

Allows you to create and assign restriction filters. These filters control what
kind of calls a user can make on this line.