Nortel Networks ICS 6.1 - Manual (Page 100)

91
P0603536 02 Modular ICS 6.1 Programming Record
•• Sched:Night Select options for your ringing service.
••• Service Select how you want your service activated.
••• Trunk Answer Allow the telephone to answer incoming calls arriving at any telephone on the
system.
••• ExtraDial Enter the internal telephone number of the Extra-Dial telephone. This allows
you to assign an additional Direct-dial telephone in the Norstar system for
each schedule you use.
••• Line settings Select ringing service options for each line.
•••• Show line:_ Enter the valid line number.
••••• Ring grp Press change to enter the line number of each pre-defined ring group
between 001 and 100.
••••• Aux. ringer Indicate whether the auxiliary ringer (if installed) also rings for this line when
Ringing service is on.
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
Enter the information for each of these settings as you have done for Night
sched.
• Restrn service Use these commands to select the method for activating alternate
restrictions.
•• Sched:Night Indicate how alternate call routing should be activated for each of the
schedules.
••• Service Select how you want your service activated.
•• Sched:Evening
•• Sched:Lunch
•• Sched:Sched 4
•• Sched:Sched 5
•• Sched:Sched 6
Set up activation method for each of these settings, as you have with Night
sched.
• Routing service A programming section that allows you to create up to 500 destination codes
and 999 routes to provide a dialing plan or for least cost routing.
•• Routes Create the routes to be used when a destination code is dialed.
••• Show route:_ Enter the number of the route you want to create.
•••• DialOut Enter the number, of up to 24 digits or characters, that you want this route to
dial out, if required.
•••• Use Select the line pool you want this route to use.