Nortel Networks ICS 6.1 - Manual (Page 114)

105
P0603536 02 Modular ICS 6.1 Programming Record
•••• Config Use to configure the settings for the SDI.
••••• Ptl Select the physical interface used to connect the SDI to the networking
equipment.
••••• DS0 rate Select the transmission rate of the channels (Fixed lines) assigned to the SDI.
••••• TxClk src Select whether data travelling through the SDI is synchronized using timing
(clocking) from the SDI or the DTE.
••••• TxClk invrsn Invert the signal used by the SDI to synchronize data from the DTE to adjust
for round trip delays between the SDI and DTE.
••••• Data invrsn Invert data travelling through the SDI before routing it to the T1 connection or
DTE to allow the SDI to support HDLC/SDLC (a transmission standard for
data) protocol.
•••• Lp state Show the direction of the loopback, if any, generated by the SDI.
•••• Fixed access Assign fixed lines to supported data modules:
• IDM 200
• BayStack
• SDI).
• Maintenance These commands allow you to make diagnostic checks on the system.
• System version Record the system version shown on the display.
• Port/DN status View the Port/DN status.
• Module status View the Module status.
• Sys test log View items in Sys test log.
• Sys admin log View items in log.
• Network evt log View the items in the Network Log.
This log keeps a record of events and alarms involving the digital network
interface.
• Provisioning Place BRI loops in or out of service.
• Tests Run and list any BERT-set tests.
• CSU stats View the performance statistics for your T1 lines.
• Diagnostic tools Diagnostic tools programming performed by experienced personnel.
• Link Status
• Usage metrics
•• Hunt Groups Use to gather statistical information about Hunt group usage.
•• Call-by-Call Use to gather statistical information about PRI CbC calls.