Nortel Networks ICS 6.1 - Manual (Page 110)

101
P0603536 02 Modular ICS 6.1 Programming Record
•• Call Restrns These commands allow you to assign dialing filters to room occupancy
states.
••• Vacant This command notes if the Room is empty or occupied.
•••• Use flt: Enter the dialing filter for the room state. The filters range from 00 to 99.
••• Basic Indicate the filter to be assigned for that level of room occupancy.
••• Mid Indicate the filter to be assigned for that level of room occupancy.
••• Full Indicate the filter to be assigned for that level of room occupancy.
•• Service time These commands allow you to program a system-wide time when occupied
rooms change state from Service done to Needs service.
••• Hour Enter the hour.
••• Minutes Enter the minutes.
•• Alarm These commands allow you to configure the Alarm operation.
••• Attn attempts Enter the number of times the Alarm time feature attempts to get the attention
of the occupant before cancelling.
••• Retry intrvl Enter the interval period between each Alarm attempt.
This setting is in minute intervals.
••• Attn duration Set the period for which a set alerts on each alarm attempt.
This setting is in seconds.
••• Time format Choose if alarm times are entered using a 12 hour or 24 hour clock.
•• Expired Alarms These commands allow you to determine how the system will notify you about
expired alarms.
••• Notify set Use this command to choose whether the set where the alarm was
programmed will be notified if the alarm expires.
••• Use Tone Use this command to choose what tone will be used if the set is notified that
an alarm has expired.
• Network services These commands are used for MCDN connections only.
•• ETSI (profile 2 only) These features can be supplied by your service provider over ETSI lines.
••• Netwrk Redirection (NCD) Use this command to indicate whether you want to be able to call forward
calls over the network.
••• MCID Use this command to indicate whether the MCID feature code can be used to
record call information at the CO.
•• MCDN (profiles 1, 2, and 4) Press Next to move to next entry.
••• NetwkICCL Select whether you want ISDN Call Control Limitation to be set for your
MCDN network.
••• TRO Select whether you want Trunk Route Optimization to be active on the MCDN
networks.
••• TAT Select whether you want Trunk Anti-Tromboning to be set for your MCDN
network.
• SM Sets Indicate the number of silent monitoring telephones that you want to allow in
your system (1 - 30). Note that telephones that have been allowed as SM
supervisors cannot be monitored.