Nortel Networks ICS 6.1 - Manual (Page 92)

83
P0603536 02 Modular ICS 6.1 Programming Record
••• DND on Busy Select whether or not an incoming call rings if the user already is on another
call.
••• Handsfree Select whether handsfree will be available to a telephone.
••• HF answerback Select whether a user can automatically answer a voice call without lifting the
receiver or pressing the
Å
button. It is always turned off for a T7100
telephone.
••• Pickup grp Any user in a pickup group can answer calls to any other telephone in their
group using the Call Pickup-group feature (
²àÞ
). Choose one of nine
pickup groups, or choose None to disable the feature for this telephone.
••• Page zone Assign a page zone to allow this set to receive pages, or choose None to
prevent pages at this telephone.
••• Paging Select whether paging can be performed from this Norstar telephone.
••• D-Dial Select whether you can call the Direct-dial telephone from this telephone
using the Direct-dial digit.
••• Priority call If a call is critical for the called party to receive, you can program this
telephone to interrupt calls or to override Do Not Disturb at another Norstar
telephone when you enter
²ßá .
A priority call can be refused at the set you call if the called party enters Do
Not Disturb (
²¡Þ
).
However, a priority call cannot be blocked by at a telephone that is already in
Do Not Disturb mode.
••• Hotline Select whether a telephone number will be dialed automatically when a user
lifts the receiver or presses the button on the memory keys that is designated
as the handsfree/mute button.
•••• Intrnl#:None Choose Intrnl to enter an internal Norstar telephone as the hotline.
••••• Intrnl#:_______ Enter the internal DN you want to use as the hotline.
•••• Extrnl#:None Choose Extrnl to enter an external telephone as the hotline.
••••• Extrnl#:_______ Enter the external DN you want to use as the hotline.
••• Aux. ringer Select whether an external auxiliary ringer will ring for incoming calls at this
telephone.
Note: The customer-supplied ringer hardware must be installed before the
feature will work.
••• Allow redirect Select whether to allow this telephone to redirect lines.
••• Redirect ring Select whether a telephone rings briefly when a call is redirected by the Line
Redirection feature (
²¡Ý ).
••• ATA settings Analog telephones or other devices which are connected to the ICS using an
Analog Terminal Adapter (ATA) may need the additional programming found
under this subheading.
•••• ATA ans timer This setting determines the timing between when an ATA-connected device
dials out and when the device becomes ready to receive DTMF tone from the
far end analog device.
•••• ATA use Choose the setting that indicates where the ATA is situated (On Site/Off Site)
•••• MsgIndicate Select the type of message indicator the ATA-connected device provides.
(None, Tone, Lamp).