Nortel Networks ICS 6.1 - Manual (Page 113)

104
Modular ICS 6.1 Programming Record P0603536 02
••• D-packet servce Configure the D-packet service for this loop.
Only one loop on each card can support D-channel packet service.
•••• D-packet servce Turn the D-packet service for this loop on or off.
•••• Lp001 Select the loop that supports the D-packet service:
• S-loop (for BRI-ST Card)
• LT-loop (for BRI-U2 or BRI-U4 Card)
••• TEIs Add up to eight Terminal Endpoint Identifiers (TEIs).
Each TEI is supplied by your service provider. A TEI is associated with an
ISDN device.
•••• TEI Enter the two-digit TEIs supplied by your service provider.
••• ClockSrc Determine the type of clock source.
••• ONN blk Determine if ONN blocking will be allowed for BRI loops.
••• SPID2 Enter the second SPID supplied by your service provider, if applicable.
• Cd2 on KSU Select the type of card that occupies the second slot in the ICS.
Note: The slots are numbered from left to right.
Version note: If your system is using 4x8 software which has not been
upgraded, this setting does not appear.
•• Mod 03
•• Mod 04
•• Mod 05
•• Mod 06
•• Mod 07
•• Mod 08
View and program the cards installed in the modules.
Note: MICS-XC also has modules 9-14.
••• StnMod Indicate that the module is a Station Module
••• ASM Indicate that the module is an Analog Station Module
••• TrunkMod Indicate that the module is a Trunk Module
••• DataMod Indicate that the module is a datamodule:
• Norstar Integrated Data Module 200 (IDM 200)
• BayStack
• Synchronous Data Interface (SDI)
•••• Type Indicate the type of data module.
You can change the type if no data module is currently attached to the
expansion port.
•••• IP address Indicate the IP address for a data module (BayStack only).
•••• Fixed access Assign Fixed lines to supported data modules
• IDM 200
• BayStack
• SDI).
•••• Switched access Assign lines used for dial-up network access to the data module (BayStack
only).
••••• Line assignment Select fixed lines the data module (BayStack only) uses for switched access.
••••• Line pool access Indicate line pool switched access for the data module (BayStack only).
•••• DataMod NVRAM Use to reset the NVRAM of the IDM 200 data module to the factory defaults.