Config users passwd, Config users delete, Config users snmpv3 authentication – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual
Page 99: Config users snmpv3 encryption, Config users passwd -57, Config users delete -57, Config users snmpv3 authentication -57, Config users snmpv3 encryption -57
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands
7-57
202-10010-01
config users passwd
This command changes the password of an existing operator. The password is up to eight
alphanumeric characters. The name and password are not case-sensitive.
When a password is changed, a prompt will ask for the operator’s former password. If none, press
enter.
Default
Blank (indicating no password)
Format
config users passwd
config users delete
This command removes an operator.
Format
config users delete
Note:
The admin user account cannot be deleted.
config users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The
valid authentication protocols are
none
,
md5
or
sha
. If
md5
or
sha
are specified, the user login
password will be used as the snmpv3 authentication password. The
is the login user name
for which the specified authentication protocol will be used.
Default
no authentication
Format
config users snmpv3 authentication
sha>
config users snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login user.
The valid encryption protocols are
none
or
des
. The
des
protocol requires a
key
, which can be
specified on the command line. The
key
may be up to 16 characters long. If the
des
protocol is
specified but a key is not provided, the user will be prompted for the key. If
none
is specified, a key
must not be provided. The
is the login user name for which the specified encryption
protocol will be used.
Default
no encryption
Format
config users snmpv3 encryption