NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 89)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-47
202-10010-01
config spanningtree forceversion
This command sets the Force Protocol Version parameter to a new value. The can be
one of the following:
• 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
• 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default 802.1s
Format config spanningtree forceversion <802.1d/802.1w/
802.1s>
config spanningtree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration that
this switch is currently using. The is a string of at most 32 characters.
Default The base MAC address displayed using hexadecimal notation as specified in
IEEE 802 standard.
Format config spanningtree configuration name
config spanningtree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The is a number in the range of 0 to
65535.
Default 0
Format config spanningtree configuration revision <0-65535>
show spanningtree port
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The is the desired switch port.
Format show spanningtree port
Port mode Enabled or disabled.