NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 67)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-25
202-10010-01
Format show port
Slot.Port The physical slot and physical port.
Type If not blank, this field indicates that this port is a special type of port. The
possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring screens to find
out more information.
Lag - this port is a member of a Lag. Look at the Lag screens to find out more
information.
Probe - this port is a probe port. Look at the Port Mirroring screens to find out
more information.
Admin Mode Selects the Port control administration state. The port must be enabled in order
for it to be allowed into the network. - May be enabled or disabled by selecting
the corresponding line on the pull-down entry field. The factory default is
enabled.
Physical Mode Selects the desired port speed and duplex mode. If auto-negotiation support is
selected, then the duplex mode and speed will be set from the auto-negotiation
process. Note that the port's maximum capability (full duplex -100M) will be
advertised. Otherwise, this object will determine the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status Indicates the port speed and duplex mode.
Link Status Indicates whether the Link is up or down.
Link Trap This object determines whether or not to send a trap when link status changes.
The factory default is enabled.
LACP Mode Displays whether LACP is enabled or disabled on this port.
config port adminmode
This command enables or disables a port.
Default enable
Format config port adminmode
config port flowcontrol
This command enables or disables flow control on the specified interface.
Format config port flowcontrol