NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 116)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-74 Switching Commands
202-10010-01
User This field displays the users configured locally to have access to the specified
port.
show users authentication
This command displays all user and all authentication login information. It also displays the
authentication login list assigned to the default user.
Format show users authentication
User This field lists every user that has an authentication login list assigned.
System Login This field displays the authentication login list assigned to the user for system
login.
802.1x Port Security This field displays the authentication login list assigned to the user for 802.1x
port security.
System Utilities
This section describes system utilities.
save config
This command permanently saves configuration changes to Non-Volatile Random Access
Memory (NVRAM).
Format save config
logout
This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out. See “save config” on page 74.
Format logout
transfer upload mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default xmodem . This is valid only when the transfer is initiated by the serial EIA 232
port.