NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 77)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-35
202-10010-01
config protocol interface add
This command adds the physical interface to the protocol-based VLAN identified by
. If is selected, all physical interfaces will be added to this protocol group. A
group may have more than one interface associated with it. Each interface and protocol
combination can only be associated with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
Default none
Format config protocol interface add
all>
config protocol interface remove
This command removes the from this protocol-based VLAN group that is identified
by this . If is selected, all ports will be removed from this protocol group.
Default none
Format config protocol interface remove
show garp info
This command displays Generic Attributes Registration Protocol (GARP) information.
Format show garp info
GMRP Admin Mode This displays the administrative mode of GARP Multicast Registration Protocol
(GMRP) for the system.
GVRP Admin Mode This displays the administrative mode of GARP VLAN Registration Protocol
(GVRP) for the system.
show garp interface
This command displays Generic Attributes Registration Protocol (GARP) information for one or
all interfaces.
Format show garp interface
Interface This displays the slot.port of the interface that this row in the table describes.
Join Timer Specifies the interval between the transmission of GARP PDUs registering (or
re-registering) membership for an attribute. Current attributes are a VLAN or
multicast group. There is an instance of this timer on a per-Port, per-GARP