NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 81)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-39
202-10010-01
config igmpsnooping adminmode
This command enables or disables IGMP Snooping on the system. The default value is disable.
Format config igmpsnooping adminmode
config igmpsnooping groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default 260 seconds
Format config igmpsnooping groupmembershipinterval <1-3600>
config igmpsnooping maxresponse
This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3600 seconds.
Default 10 seconds
Format config igmpsnooping maxresponse <1-3600>
config igmpsnooping mcrtrexpiretime
This command sets the Multicast Router Present Expiration time on the system. This is the amount
of time in seconds that a switch will wait for a query to be received on an interface before the
interface is removed from the list of interfaces with multicast routers attached. The range is 0 to
3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
Default 0
Format config igmpsnooping mcrtrexpiretime <0-3600>