NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 95)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 7-53
202-10010-01
config spanningtree mst vlan add
This command adds an association between a multiple spanning tree instance and a VLAN. The
VLAN will no longer be associated with the common and internal spanning tree. The instance
is a number that corresponds to the desired existing multiple spanning tree instance. The
corresponds to an existing VLAN ID.
Format config spanningtree mst vlan add
config spanningtree mst vlan remove
This command removes an association between a multiple spanning tree instance and a VLAN.
The VLAN will again be associated with the common and internal spanning tree. The instance
is a number that corresponds to the desired existing multiple spanning tree instance. The
corresponds to an existing VLAN ID.
Format config spanningtree mst vlan remove
config spanningtree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance. The instance
is a number that corresponds to the desired existing multiple spanning tree instance. The
priority is a number within a range of 0 to 61440 in increments of 4096.
Default 32768
Format config spanningtree mst priority <0-61440>
config spanningtree mst port pathcost
This command sets the path cost for a specific port within a multiple spanning tree instance. The
instance is a number that corresponds to the desired existing multiple spanning tree
instance. The is the desired switch port. The pathcost can be specified as a number in
the range of 1 to 200000000 or auto. If "auto" is specified, the pathcost value will be set based on
Link Speed.
Default auto
Format config spanningtree mst port pathcost
<1-200000000/auto>