NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 86)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-44 Switching Commands
202-10010-01
The parameter must identify a valid VLAN.
Up to 100 static MAC filters may be created.
Format config macfilter create
config macfilter remove
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address on the VLAN . The parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The parameter must identify a valid VLAN.
Format config macfilter remove
config macfilter addsrc
This command adds the to the source filter set for the MAC filter with the MAC
address of and VLAN of . The parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The parameter must identify a valid VLAN.
The parameter identifies the source port to be added to the source port filter set for the
MAC filter.
If all is selected, all ports will be added to the source port filter set.
Format config macfilter addsrc
config macfilter delsrc
This command removes a port from the source filter set for the MAC filter with the MAC address
of and VLAN of . The parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The parameter must identify a valid VLAN.
The parameter identifies the source port to be removed from the source port filter set
for the MAC filter.