NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 41)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Quick Startup 6-9
202-10010-01
Solution 1
All traffic entering the ports is tagged traffic. Since the traffic is tagged, the PVID configuration
for each port is not a concern. The network card configuration is as follows:
• Devices on Project A should tag all traffic with 'VLAN 2'
• Devices on Project B should tag all traffic with 'VLAN 3'
• Devices on Project C should tag all traffic with 'VLAN 4'
• Devices on Project P should tag all traffic with 'VLAN 9'
Solution 2
The network card configuration for devices on Project A, B and C should be set to NOT tag traffic.
To take care of these untagged frames configure the following:
• config vlan ports pvid 2 0.1
• config vlan ports pvid 2 0.2
• config vlan ports pvid 3 0.3
• config vlan ports pvid 3 0.4
• config vlan ports pvid 4 0.5
• config vlan ports pvid 4 0.6
create VLAN 4 config vlan create 4
config vlan participation include 4 0.5
config vlan participation include 4 0.6
create VLAN 9 config vlan create 9
config vlan participation include 9 0.1
config vlan participation include 9 0.2
config vlan participation include 9 0.3
config vlan participation include 9 0.4
config vlan participation include 9 0.5
config vlan participation include 9 0.6
config vlan participation include 9 0.7
Table 6-9. Creating the VLANs
VLAN Command