NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 94)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-52 Switching Commands
202-10010-01
config spanningtree cst port priority
This command sets the Port Priority to a new value for use within the common and internal
spanning tree. The is the desired switch port. The priority is a number in the
range of 0 to 240 in increments of 16.
Default 128
Format config spanningtree cst port priority <0-
240>
config spanningtree cst port edgeport
This command specifies if a port is an Edge Port within the common and internal spanning tree.
This will allow the port to transition to Forwarding State without delay. The is the
desired switch port. The edgeport can either be "true" or "false".
Default false
Format config spanningtree cst port edgeport
config spanningtree mst create
This command adds a multiple spanning tree instance to the switch. The instance is a
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The
maximum number of multiple instances supported by managed switch software is 4.
Format config spanningtree mst create
config spanningtree mst delete
This command removes a multiple spanning tree instance from the switch and reallocates all
VLANs allocated to the deleted instance to the common and internal spanning tree. The instance
is a number that corresponds to the desired existing multiple spanning tree instance to be
removed.
Format config spanningtree mst delete