NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 68)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-26 Switching Commands
202-10010-01
config port linktrap
This command enables or disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See “config trapflags
linkmode” on page 21 for more information.
Format config port linktrap < slot.port|all>
config port physicalmode
This command sets the speed and duplex setting for the interface.
Format config port physicalmode
<100h|100f|10h|10f>
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 100BASE-T full duplex
config port lacpmode
This command enables or disables Link Aggregation Control Protocol (LACP) on a port. The
possible values for are enable and disable. The default value is disable.
Format config port lacpmode
config port autoneg
This command enables or disables automatic negotiation on a port. The possible values for
are enable and disable. The default value is enable.
Format config port autoneg
show lag
This command displays an overview of all link aggregations (LAGs) on the switch.
Format show lag