NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 118)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-76 Switching Commands
202-10010-01
transfer upload filename
This command sets the name for the file that is uploaded from the switch. The switch “remembers”
the last file name used.
Append the file path to the file name if the string is less than 31 characters. Otherwise, use the
“transfer upload path” command, and the File Name will be appended to the File Path.
Note: This command is valid only when the Transfer Mode is TFTP. See “transfer upload mode” .
Default Blank
Format transfer upload filename
transfer upload datatype
This command sets the type of file to upload from the switch.
Format transfer upload datatype
The datatype is one of the following:
config Configuration file.
errorlog Error log.
msglog Message log.
traplog Trap log (the default).
transfer upload start
This command starts an upload transfer after displaying current settings and upon confirmation.
Format transfer upload start
transfer download mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default xmodem . This is valid only when the transfer is initiated by the serial EIA 232
port.
Format transfer download mode