Config users snmpv3 accessmode, Show loginsession, Config loginsession close – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual
Page 100: Security commands, Config users snmpv3 accessmode -58, Show loginsession -58, Config loginsession close -58, Security commands -58
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-58
Switching Commands
202-10010-01
config users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
readonly
or
readwrite
. The
is the login user name for which the
specified access mode will apply.
Default
readwrite
for admin user; readonly for all other users
Format
config users snmpv3 accessmode
readwrite>
show loginsession
This command displays current telnet and serial port connections to the switch.
Format
show loginsession
ID
Login Session ID.
User Name
The name the user will use to login using the serial port or Telnet. A new user
may be added to the switch by entering a name in a blank entry. The user name
may be up to 8 characters, and is not case sensitive. Two users are included as
the factory default, admin and guest.
Connection From
IP address of the telnet client machine or EIA-232 for the serial port connection.
Idle Time
Time this session has been idle.
Session Time
Total time this session has been connected.
config loginsession close
This command closes a telnet session.
Format
config loginsession close
Security Commands
This section describes commands used for configuring security settings for login users and port
users.
This command permanently saves configuration changes to Non-Volatile Random Access
Memory (NVRAM).
Format
save config