NEC Express 5800/320Lc - Manual (Page 72)

2-38 General Description
CD-ROM Drive
NEC Express5800/ft series has a CD-ROM drive on the front panel. It is a device used to read data
from a CD-ROM (compact disc read-only memory). Compared to a floppy disk, a CD-ROM allows
for larger volume and fast data readout.
CAUTION
Observe the following instructions to use the server safely. There are risks of a
burn, injury, or damage to physical assets. For details, see PRECAUTIONS
FOR SAFETY in Chapter 1.
Do not leave the CD tray ejected.
About the CD-ROM Drive of NEC Express5800/ft series
Each PCI module contains a single CD-ROM drive in NEC Express5800/ft series, but only the
CD-ROM drive on the primary side can be used.
When you cannot eject a CD-ROM
When you cannot eject the CD-ROM by pressing the eject button, follow the steps below to eject it:
Manual release hole
1. Press the POWER switch to power off the server.
2. Use a metal pin of about 1.2 mm in diameter and 100 mm long (alternatively, you can use
a fairly large paper clip after straightening). Insert it gently into the manual release hole
located to the right of the eject button until the tray is ejected.
IMPORTANT:
Do not use a toothpick, plastic pin, or other breakable objects.
If you cannot eject the CD-ROM by following the steps above, contact your sales agent.
3. Hold the tray and pull it out.
4. Take out the CD-ROM.
5. Push the tray back.