Insert/remove floppy disk – NEC Express 5800/320Lc User Manual
Page 70
2-36 General Description
Insert/Remove Floppy Disk
Before inserting a floppy disk into the drive, make sure that NEC Express5800/ft series is on and
that the drive’s USB cable is connected to the USB connector at the back of the server.
Insert a floppy disk into the drive firmly with the label side up and its protective shutter facing the
drive.
TIPS:
If you insert an unformatted disk, you will see a message that the disk cannot be read or that
needs formatting. To format a floppy disk, see your OS manual.
If you power on or restart NEC Express5800/ft series with a floppy disk left in the drive, the
server will access the floppy disk to start the system. Unless a system exits on the FD, the
server will be unable to start.
To remove a floppy disk from the drive, press the eject button.
TIPS:
Before removing a floppy disk, make sure that the access LED is off. If you eject a floppy
disk while the LED is on, the stored data could be damaged.