NEC Express 5800/320Lc - Manual (Page 130)

System Configuration 4-11
Advanced
Select "Advanced" on the Advanced menu to display the following screen.
Select Item
Select Menu
upport:
iagnostic
enabled.
F9 Setup Defaults
F10 Save Changes & Exit
F1 Help -/+ Change Values
Enter Select Esc Exit
Select Item
Select Menu Sub-Menu
Phoenix BIOS Setup Utility
Advanced
[Enabled]
Advanced Item Specific Help
Display the diagnostic
screen during POST
instead of the Logo.
The boot-time d
screen is redirection
or rompilot is
r Pause:
Boot-time Diagnostic Screen: [Disabled]
[Disabled]
RomPilot S
POST Erro
See the table below for setup options on the screen.
Option Parameter Description Your Setting
Boot-time
Diagnostic Screen [Disabled]
Enabled Specify whether to display the Power On
Self-Test (POST) screen at start-up. If
"Disabled" is selected, the NEC logo
appears while POST is in progress. (To
display POST check results, press Esc.)
If "RomPilot Support" is set to "Enabled" or
"Console Redirection" is set, this option is
unconditionally set to "Enabled".
RomPilot Support [Disabled]
Enabled Enable or disable the RomPilot (the remote
console and remote drive features during
OS start-up). If this option is set to
"Enabled", "Boot-time Diagnostic Screen" is
unconditionally set to "Enabled".
Post Error Pause [Enabled]
Disabled Specify whether to stop POST at the end of
POST when an error occurs during POST.
[ ]: Factory-set
TIPS: "RomPilot" is a BIOS feature for communications with the NEC Management Workstation
Application (NEC MWA). To use the NEC MWA for management of the server, select "Enabled"
for "RomPilot Support.” Use of the RomPilot features requires setups for the NEC MWA.