NEC Express 5800/320Lc - Manual (Page 135)

4-16 System Configuration
Option Parameter Description Your Setting
POST Pause
Monitoring
Time-out 1 - [3] - 20 Specify the POST monitoring time period during
boot-up restriction.
[ ]: Factory-set
IMPORTANT:
When connecting a Fibre Channel disk array device, change the set value of "Boot
Monitoring Time-out Period" depending on the wait time for the completion of the Fibre
Channel disk array device initialization.
Ex.: If the wait time for the completion of the Fibre Channel disk array device initialization
is 4 minutes, change the value of "Boot Monitoring Time-out Period" from 10 (default) to
14 minutes.
If you set a small value for "Boot Monitoring Time-out Period", you can shorten the waiting
time to the rebooting. It is recommended to set a value of more than 3 minutes though smaller
value setting is available when external devices are not used. As it depends on the user’s
setting environment, make sure to execute enough evaluation after the configuration of the
environment.
Option ROM
Select "Option ROM" on the Advanced menu to display the following screen and enable/disable
expansion of Option Rom BIOS on the PCI bus.
Phoenix BIOS Setup Utility
On Board SCSI: [Enable
On Board LAN 1:
On Board LAN 2:
PCI Slot 1:
PCI Slot 2:
PCI Slot 3:
Disables/enables the
mapping of the on-board
IOS SCSI B .
OM
i
Item Specific Help Option R
d]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
F1 Help -/+ Change Values F9 Setup Defaults
F10 Save Changes & Exit Sub-Menu Enter Select Esc Ex t
Select Item
enu Select M
Advanced