NEC Express 5800/320Lc - Manual (Page 189)

5-26 Installing and Using Utilities
Ethernet Adapters You Do Not Use
If an Ethernet adapter is not used (not connected to cable), set it to “Disable” in [Network
Connections] from Control Panel. If an Ethernet adapter you are about to disable has dual LAN
settings (AFT function), remove the dual LAN settings before disable it.
Monitoring in Sleep State
NEC ESMPRO Manager cannot monitor the NEC ESMPRO Agent machine in the sleep state
(system standby or system halt state).
While NEC ESMPRO Manager monitors server shutdown, the relevant NEC ESMPRO Agent
machine may be entered into the sleep state. If so, the report "server access disabled" is issued and
the status color of the server icon becomes gray. This cannot indicate whether the NEC ESMPRO
Agent machine is shut down or entered into the sleep state. Keep these in mind when operating the
system where systems to be monitored may enter the sleep state.
Printer Information’s Available Time:
When you add a new printer, install its driver and make its settings, if you do not make settings for
the available time from Add Printer Wizard, the printer’s available time (From and To) in [Printers
and Faxes] are [00:00], on the other hand, Manager’s time are [9:00]. To display them properly,
make the settings of printer from [Printers and Faxes]. The procedures are as follows;
1. Start [Printers and Faxes], and open the printer properties you want to make settings
for. (Select the [Printers and Faxes], right-click and select [Properties].)
2. Select the [Advanced] tab.
3. Enter values in the available time (From and To), and click [OK] in the [Advanced]
and [Properties] dialog boxes.
Now, you can see the correct information from Manager, too.
Hang of SNMP Service
SNMP Service has a module called “SNMP Extended Agent.” This module may be registered when
you install some software that uses SNMP Service.
If you start SNMP Service, SNMP Extended Agent is also loaded at the initialization. However, if
the initialization is not completed within a specified period, SNMP Service will hang.
It may take time to complete the initialization due to temporary high load on the system. In this case,
wait for the system load become low enough before restarting SNMP Service.