NEC Express 5800/320Lc - Manual (Page 151)

4-32 System Configuration
Configuration Settings
If you select "Configuration Settings" from the "Fast!UTIL Options" menu, the screen for setting
the configuration appears.
Host Adapter Settings
SCSI Device Settings
SCSI Bus Settings
Autoconfigure SCSI Device
Selectable Boot Settings
Restore Default Adapter Settings
Raw Nvram Data
Configuration Settings
Host Adapter Settings
If you put the cursor on "Host Adapter Settings" with keyboard cursors (
↓ and ↑) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the host
adapter appears.
The table below shows the parameters of the setting items and their factory settings.
Submenu item Parameter Description
BIOS Address - View only
BIOS Revision - View only
Adapter Serial Number - View only
Interrupt level - View only
Host Adapter BIOS [Enable]
Disable Specify whether the BIOS extension of the host
adapter is enabled or disabled.
PCI Bus DMA Burst [Enable]
Disable Specify whether the DMA burst transfer on the PCI
bus is enabled or disabled.
CDROM Boot Enable
[Disable] Specify whether the start from CD-ROM is enabled or
disabled.
Adapter Configuration [Auto]
Manual
Safe Specify whether the adapter configuration is set
automatically by BIOS, manually, or safely.
Drivers Load RISC [Enable]
Disable Specify whether the load of RISC codes is enabled or
disabled.
>4GByte Addressing Enable
[Disable] Specify whether hard disks of 4 GB or larger is used
or not.
Fast Command Porting [Enable]
Disable Do not change the factory setting.
[ ]: Factory-set