Remote set and read: rset, Profile read/save: prof – Northern UTA220/UTA220k User Manual
Page 85
UTA220/UTA220k
12-9
D-Channel X.25
RPAR?
or
RPAR?
Response:
PAR
each parameter specified by the read command and the
corresponding value.
PAR
specified in the read command.
Remote Set and Read: RSET?
These commands request, from a remote PAD, the setting or
changing of the current values of the specified X.3 parameters
and display the values after the setting or changing from the
remote PAD. This is only valid if an X.25 call is active.
A colon must be placed between the specified parameter and
its corresponding specified value. If more than one parameter
is requested to be set or changed, a comma must delimit the
value and the next parameter reference.
RSET?
Response:
PAR
each parameter specified by the set and read command and the
corresponding value.
PAR
is incorrect or cannot be changed because it is a READ ONLY
parameter (i.e., parameter 11 is a READ ONLY parameter), or
the value specified in the set and read command is an invalid
value for the specified parameter.
Profile Read/Save: PROF
These commands allow the user to load a saved, default, or
standard set of X.3 parameters from non-volatile memory or
save the X.3 parameters to one of two user profiles in
non-volatile memory. The PROF command syntax is as
follows:
PROF 90, PROF SIM: Will load the CCITT simple standard
profile.
PROF 91, PROF TRA: Will load the CCITT transparent
standard profile.
PROF NVM #(0,1): Will load from one of two specified
non-volatile memories a profile stored by the user.
PROF SAV #(0,1): Will store the current X.3 profile into one
of two non-volatile memories as specified.
PROF DEF: Will load the factory default X.3 profile.