Northern UTA220/UTA220k - Manual (Page 145)

UTA220/UTA220k
C-11
AT Command Set
%B19= Transmit Delay Range: 1-65535 default (0)
units = ms
%B20= Reset Notice 0 Normal operation
(write only 0)
1 DTE originated
2 Local procedure error
3 Incompatible destination
4 Network congestion
5 Remote procedure error
6 Reset cause unknown
Not saved in non-volatile. User may
clear. TA updates to normal at the
beginning of X.25 call.
%B99= Packet Reset, Clear,
Restart Timer Range: 0-600 default (180)
%B98= Packet Call Timer Range: 0-600 default (180)
%B97= Auto Accept Virtual Call E Enabled
D Disabled
Session Parameters: X.3 PAD
%L1= PAD Recall Using a
Character 0 None
1 DLE
32-126
default (0,1,0)
%L2= Echo 0 No echo
1 Echo
default (0,1,0)
%L3= Selection of Data Forward-
ing Characters 0 None
1 A-Z, a-z, 0-9
2
4
,,,
8
, ,
16 ,
32 , , ,
64 , , ,
,
, , , ,
,,,
, , ,
,
, , ,
default (0,126,0)
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+