Northern UTA220/UTA220k - Manual (Page 137)

UTA220/UTA220k
C-3
AT Command Set
!X4= Number of Permanent
Virtual Circuits Range: 0-255 default (0)
!X5= Number of Incoming
Logical Channels Range: 0-255 default (0)
!X6= Number of Two-Way
Logical Channels Range: 0-255 default (8)
!X7= Number of Outgoing
Logical Channels Range: 0-255 default (0)
!X8= X.25 Sequence Number
Modulus Range: 8, 128 default (8)
Port Commands: Configuration
En Local Echo Off n = 0 Echo Off
1 Echo On < default>
Qn Status Displays n = 0 Status On < default>
1 Status Off
2 Status Off during
answer mode
Vn Verbose n = 0 Numeric
1 Verbose < default>
Wn Carrier/Protocol Result
Codes n = 0 Disables < default>
1 Enables
Xn Connect Messages n = 0 Enable Result Code
0-4
1 Enable 0-5, 10-15,
17-19, 28, 32
2 Enable 0-5, 10-15,
17-19, 28, 32
3 Enable 0-5, 7, 10-15,
17-19, 28, 32
4 Enable 0-5, 7, 10-15,
17-19, 28, 32
S0= Rings Until Answer Range: 0-255 default (1)
S1? Ring Count (Read Only) Range: 0-255 default (0)
S2= Escape Character Range: 0-127 default (43)
Range: 128-255Disabled
S3= Carriage Return Character Range: 0-127 default (13)
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+