Northern UTA220/UTA220k - Manual (Page 146)

C-12
UTA220/UTA220k
AT Command Set
%L4= Selection of Idle Timer
Delay Range: 0-255 default (0,0,20)
%L5= Ancillary Device Control 0 Off
1 On in data transfer
2 On in data transfer and com-
mand
default (1,1,0)
%L6= Control of PAD Service
Signals 0 Suppressed
1 All but prompt in standard for-
mat
5
All
default (0,1,0)
%L7= Action on receipt of break
signal from DTE 0 None
1 Send an interrupt packet
2 Send a reset packet
5 Send interrupt and indication
of
break packets
8 Escape from data state
21 Send interrupt and indication
of
break packets and set %L8 to
1
default (5,2,2)
%L8= Discard output to DTE 0 Normal Data Delivery
1 Discard output to DTE
default (0,0,0)
%L9= Padding after carriage
return Range: 0-255 default (0,0,0)
%L10= Line Folding Range: 0-255 default (0,0,0)
%L11= DTE Speed 2 300
3 1200
4 600
12 2400
13 4800
14 9600
15 19200
16 38400
default (16,16,16)
%L12= Flow Control of the PAD 0 Off
1 Use \Q
default (0,1,0)
Table C-1: UTA 220 AT Command Set (Continued)
Command Description Value
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+