Netopia 3300 - Manual (Page 313)

Security 10-49
Once you make the selection, if you factor y Default the Router, it will reboot with the saved configuration you
have selected.
To remove the saved configuration from being the Factor y Default, select Remove Factory Default
Configuration and press Return. This will remove the configuration from being used as the Factor y Default.
It does not, however, delete the configuration, so you can still re-use it at any time.
TFTP
You can also send or receive your stored configuration files via TFTP. You select the stored configuration files
from pop-up menus in the TFTP File Transfer screen in the Utilities & Diagnostics menu, as shown.
Configuration Management
Save Current Configuration as...
Replace Existing Configuration...
Boot from a Configuration...
Delete a Configuration...
Factory Default from Configuration: HappyInternet
Remove Factory Default Configuration
Return/Enter to select Factory Default Configuration.
Trivial File Transfer Protocol (TFTP)
TFTP Server Name:
Firmware File Name:
GET ROUTER FIRMWARE FROM SERVER...
Config File Name: +-----------------------+
+-----------------------+
Get Configuration Destination... | Current Configuration |
GET CONFIG FROM SERVER... | Backup Config |
| HappyInternet |
Send Configuration... | Type Name |
SEND CONFIG TO SERVER... +-----------------------+
TFTP Transfer State -- Idle
TFTP Current Transfer Bytes -- 0
Up/Down Arrow Keys to select, ESC to dismiss, Return/Enter to Edit.