Netopia 3300 User Manual
Page 158
5-26 Firmware User Guide
Select Display/Change Input Filter.
Display/Change Input Filter screen
Select Input Filter 1 and press Return. In the Change Input Filter 1 screen, set the Destination Por t information
as shown below.
Select Input Filter 2 and press Return. In the Change Input Filter 2 screen, set the Protocol Type to allow GRE as
shown below.
Main
Menu
System
Filter
Sets
Display/Change
Filter Set
Configuration
Basic
Firewall
+--#----Source IP Addr----Dest IP Addr------Proto-Src.Port-D.Port--On?-Fwd--+
+---------------------------------------------------------------------------+
| 1 0.0.0.0 0.0.0.0 TCP NC =2000 Yes No |
| 2 0.0.0.0 0.0.0.0 TCP NC =6000 Yes No |
| |
+---------------------------------------------------------------------------+
Change Input Filter 1
Enabled: Yes
Forward: Yes
Call Placement/Idle Reset: No Change
Force Routing: No
Source IP Address: 0.0.0.0
Source IP Address Mask: 0.0.0.0
Dest. IP Address: 0.0.0.0
Dest. IP Address Mask: 0.0.0.0
TOS: 0
TOS Mask: 0
Protocol Type: TCP
Source Port Compare... No Compare
Source Port ID: 0
Dest. Port Compare... Equal
Dest. Port ID: 1723
Established TCP Conns. Only: No
Return/Enter accepts * Tab toggles * ESC cancels.
Enter the packet specific information for this filter.