Printronix T4204 - Manual (Page 163)

SPC Coax Params
163
SPC Coax Params
SPC Type
• Avatar Compatible. This option causes the printer to line wrap at 132
characters despite the current print density allowing more characters per
line.
• PTX NI (Printronix Non-impact). This option causes the printer to not
line wrap at 132 characters.
Logical Buff Size
Refers to the size of the printer buffer, which should be set the same as the
host screen (buffer) size. If the host screen size is unknown, use 1920.
Image Buff Size
This option refers to the printer base buffer size. This size must be set to a
value greater than or equal to the Logical Buffer Size.
Intervention Req
• Send to Host. The printer sends a signal to the host computer when the
CANCEL key is pressed or a printer fault or hold mode time-out occurs.
• Do Not Send. No signal will be sent to the host computer.
CTHI
(from page 148)
Logical Buf
Size
Image Buf Size Intervention
Req
Buffer Print
Translation Tbl PA1 PA2 Buffer Reprint SPC Null Supp
960
1920*
2560
3440
3564 4K*
2K Send To Host*
Do Not Send Disable*
Enable
Disable*
Enable
* = Factory Default
SPC Type
SPC Coax
Params
Simp Prot
Conv
PTX NI*
Avatar Comp
NL @ MPP+1
On*
Off