Printronix T4204 - Manual (Page 139)

LinePrinter Plus Serial Matrix Emulation
139
LinePrinter Plus Serial Matrix Emulation
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8 or 10.3 LPI.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
• CR = CR. Does not insert an extra Line Feed after each Carriage Return.
• CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
The next print position will be print position 1 of the next line.
Auto LF
The Auto LF option defines the printer actions when print data is received past
the forms width setting.
• Enable. Performs an automatic carriage return and line feed when data is
received past the forms width.
• Disable. Discards any data past the forms width.
Printer
Protocol
(from page 125)
Control Code
06
Define CR
Code
Auto LF Overstrike Define LF
Code
Printer Select
Alt. Set 80-9F Character Set
6.0 LPI
8.0 LPI*
10.3 LPI CR = CR*
CR = CR + LF Enable*
Disable Enable*
Disable LF = LF*
LF = CR + LF Disable*
Enable
Control Code*
Printable (see page 141)
* = Factory Default
Serial Matrix
SFCC d
Command
Even dot plot*
Double high