Printronix T4204 - Manual (Page 161)

Twinax Emulation Menu
161
Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic Error Action)
command. For more information about the SGEA command, refer to the
Coax/Twinax Programmer’s Reference Manual.
• Enable. The host setting for the SGEA used by the printer. If the SGEA
command is requested to stop on graphic errors, the printer will stop
when a graphic error is detected.
• Disable. Ignores the SGEA command from the host. The printer does not
stop when an error is detected; instead, it substitutes the character
selected in the Graphic Chek Code parameter.
Graphic Chek Code
Specifies the replacement character to print in place of any unprintable
character that is received from the host. Choose a character from hex 40
through hex FE. The character becomes the printer default when:
• The printer is powered off and then powered on.
• An SGEA command specifies to use the operator panel default.
• The Graphic Chek Err parameter is disabled.
LAC Option
Allows the host system to load alternate character images into the printer.
This may be used for designing graphics, bar codes, and charts, or for printing
in foreign languages.
• Enable. Prints the LAC character as defined.
• Disable. Ignores the LAC definition from the host and prints from the
currently selected character set.
LAC Approx.
Specifies whether or not to use the LAC Approximation feature. For more
information about the LAC Approximation feature, refer to the
Coax/Twinax
Programmer’s Reference Manual.
• On. (default) Always converts the emulated character cells to standard
cells.
• Off. Passes the character data through the printer without conversion.
Set Text Orientn
Specifies the direction in which characters are printed on the page. This
allows the printer to print languages that are printed right to left instead of left
to right.
• Control By Host.
• Left To Right.
• Right To Left.