Printronix P9000 Series - Manual (Page 42)

Configuration 3-2
From the main configuration menus below, related configuration parameter values can be disĆ
played and selected.
D Ribbon Life xxx%
D Character Set
D Application Compatibility
D Paper Format
D Host Interface
D Load Parameters
D Save Parameters
D Diagnostics
NOTE: The xxx% in the Ribbon Life menu will not be displayed in the LCD message if
the RibbonMinder feature is disabled.
Once the ENTER switch is unlocked, selected values can be saved as the current configuration
by displaying the value in the LCD and pressing ENTER. You can exit from a configuration
menu by pressing CLEAR which will place the printer off line.
NOTE: If an E" is displayed in the upper right corner of the LCD, the VFU is enabled. If
an L" is displayed in the lower right corner of the LCD, the VFU is loaded.
Configuration Printout
The configuration printout lists all of the currently selected configuration parameter values.
Figure 3-1 is a sample configuration printout. Configuration parameters on the printout are
listed in the same order as the configuration menu via control panel.
The following general procedure can be used to obtain a configuration printout. Refer to the
Control Panel Configuration Diagrams beginning on page 3-11 for an illustration of the butĆ
tons required to select and display the menus and values. When this mode is exited, the previĆ
ous print mode and LPI is restored, and all print attributes are canceled. All other format
parameters are unaffected.
1. Place the printer off line and raise the printer cover.
2. Select and display the CONFIGURATION PRINTOUT menu in the DIAGNOSTICS
menu by pressing MENU DOWN and then PREV until DIAGNOSTICS appears in the
message display.
3. Press MENU DOWN to display CONFIGURATION PRINTOUT in the message disĆ
play.
4. Press RUN/STOP. The configuration printout will print.
5. Press CLEAR to return to OFFLINE READY.
6. Close the printer cover and place the printer on line.