Printronix P9000 Series - Manual (Page 148)

Programming 6-50
Line Spacing 8 or 10.3 lpi (One Line Only)
ASCII Hex Decimal
P-Series ACK 06 06
SFCC f SFCC 66 SFCC 102
Serial N/A N/A N/A
Purpose Selects line spacing of 1/8 or 7/72 inch for the current line only.
Comment The default line spacing is reselected automatically after one line. Line spacĆ
ing may be selected either by the control panel 6/8 LPI switch or by line spacĆ
ing control codes. The control code setting will override the setting on the
display.
8 and 10.3 lpi spacing for one line applies only to P-Series programming comĆ
patibility.
If the alternate line spacing selected from the control panel is 8 lpi, the ACK
control code will set the line spacing to 8 lpi. If 10.3 lpi was selected from the
control panel, the ACK control code will set the line spacing to 10.3 lpi
(7/72").
In Serial Matrix printer protocol, this line spacing command for a single line
can be accomplished by using ESC J (Line Feed n/216-Inch), where: n=27
for 8 lpi, or n=21 for 10.3 lpi, and Line Feed = Newline.
Serial Matrix compatible control code ESC 0 and P-Series SFCC 0 can be
used for continuous 1/8-inch line spacing.
Example The following example illustrates printing a single line of text at 8 lpi.