Paradyne T1 T1 Access Mux 926x - Manual (Page 53)

User Interface
4-9 9161-A2-GH30-30 April 1998
If entering yes to prompt . . . Then . . .
Reset COM Port usage H Port Type is set to Terminal.
H Data Rate (Kbps) is set to 19.2.
H Character Length is set to 8.
H Stop Bits is set to 1.
H Parity is set to None.
H External Device Commands is set to Disable.
Reload Factory Defaults All factory-loaded configuration and control
settings contained in the Default Factory
configuration area are loaded.
If no (or n) is entered, or if no selection is made within 30 seconds, the T1
access unit returns to the condition of operation it was in when the system
pause was initiated, with the COM port settings returning to their configured
states.
If you chose yes, the T1 access unit resets itself, going through a Device
Self-Test. Connectivity is restored and the Main Menu screen appears.