Paradyne T1 T1 Access Mux 926x - Manual (Page 272)

SNMP Cross-Reference
D-14 9161-A2-GH30-30 April 1998
Table D-1. SNMP MIB to User Interface Command Cross-Reference (14 of 16)
User Interface Command SNMP MIB Object
CONFIG
main/config/load followed by
main/config/save: Set:
devConfigAreaCopy to the selected area:
active-to-customer1,
factory1-to-active, etc.
main/config:
Accept Configuration Mismatch
Set:
devCfgCardAction to
accept
main/config/network:
Network Interface
Line Framing Format
Line Coding Format
ANSI Performance Report Msgs.
Management Link
DDL Rate
Network Time Slot
Circuit Identifier
Set/Read:
ifAdminStatus to up or down
dsx1LineType
dsx1LineCoding
dsx1Fdl
dsx1Fdl (
fdl only)
ifSpeed
devDs1FracTable entry, with devDs1FracIndex for DDL
dsx1Circuit Identifier
main/config/dsx:
Interface Status
Line Framing Format
Line Coding Format
Set/Read:
ifAdminStatus to up or down
dsx1LineType
dsx1LineCoding
main/config/sync:
Port Status
Port Type
Port Base Rate
Transmit Clock Source
Embedded Data Link
EDL Management Link
Invert Transmit and Received Data
Set/Read:
ifAdminStatus to up or down
rs232PortType
devSyncDataPortConfigBaseRate
rs232SyncPortClockSource to
internal or external
ifAdminStatus to up/down of EDL for this port
devPortUsage to none or netLink
rs232SyncPortEncoding to nrzi
main/config/voice_port:
Port Status
Signaling Type
Terminating Impedance
Wink Delay
Wink Duration
Rx Gain
Tx Gain
Ring-back Tone
Trunk Cond. in CGA
Operating Mode
Set/Read:
ifAdminStatus to up or down
devVoiceConfigSignalingType
devVoiceConfigTermImpedance
devVoiceConfigWinkDelay
devVoiceConfigWinkDuration
devVoiceConfigRxGain
devVoiceConfigTxGain
devVoiceConfigRingBackTone
devVoiceConfigTrunkCondInCGA
Read:devVoiceConfigOperatingMode