Philips bSure 1 - Manual (Page 43)

<
• Always use the same type of lamp: See ‘Optional accessories’ for the correct type of lamp
for your projector.
• Do not touch lamp or point lamp housing opening at anyone.
• Do not drop, as the impact may cause the lamp to break.
8 Place the lamp holder in the guiding slots and insert into the lamp compartment.
9 Tighten screw B again.
10 Put the lamp door back in place and press tab A back in its original position.
– The Mains inlet socket will open again.
11 Insert the mains lead into both the projector Mains inlet socket and the wall socket.
12 Press the Standby button to switch on the projector.
13 Reset the lamp life time (see ‘Resetting the lamplife time’).
14 Dispose of the old lamp in special chemical disposal bins.
1 Press Menu.
– The menu bar appears on the screen.
2 Use cursor control to select ‘Settings’ in the menu bar.
3 Use cursor control to select ‘Lamp counter’ in the sub menu.
4 Press OK for 3 seconds to reset the lamp counter.
5 If required, select another item you wish to adjust or press Menu to exit.
Resetting the lamplife
time
6. Maintenance
Philips Multimedia Projector
43 English User guide cClear
B
A
Menu OK AV
Mute Source
Stand by
Lamp
Temp
Menu OK AV Mute Source
Stand by
Lamp
Temp
LASER LASER
VOolume VOolume
OK OK Menu Menu
Standby Standby On On AV Mute AV Mute
Select Select Mode Mode Source Source
Mouse Mouse RIGHT RIGHT LEFT LEFT RIight RIight Left Left
6
Window Window
XP cClear10 English (good) 24-07-2003 15:52 Pagina 43