Philips bSure 1 - Manual (Page 41)

>
Switch off and disconnect the projector before cleaning.
1
Press the Standby button twice to switch off the projector.
– The Standby indicator starts blinking orange.
2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
Cleaning the cabinet
•
When the cabinet is dusty, clean it by gently wiping with a soft cloth.
• A chamois leather slightly moistened with water is sufficient for cleaning the housing.
• Do not use cleaning agents as they may harm the housing.
Cleaning the lens
•
When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft
brush or lens cleaning paper. Never touch the lens with your fingers.
– The lens is likely to become mouldy if left dirty.
Cleaning the dust filter
Make sure to clean the dust filter regularly.
1
Switch off the projector and wait until the cooling fan has stopped before disconnecting the
projector.
2 Turn the projector over and place it on a soft surface. Never place the projector on the side
where the connections are located!
3 Press tab A and remove filter holder B from the projector.
4 Press clamp C, open the holder and remove the filter.
5 While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with
a vacuum cleaner.
6 Press clamp C, put the filter back in place and release clamp C. Firmly press the filter edges
in place.
7 Close the filter holder.
8 Press tab A and insert the filter B into the projector.
We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn
or damaged filter may seriously damage the projector.
When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 0157 0).
The projector power cannot be switched on again unless the filter holder is installed correctly.
Cleaning
Caution
Important
Notes
6. Maintenance
Philips Multimedia Projector
41 English User guide cClear
A
B
C C
A
B
Menu OK AV Mute Source
Stand by
Lamp
Temp
Menu OK AV Mute Source
Stand
by
Lamp
Temp
LASER LASER
VOolume VOolume
OK Menu Menu
Standby Standby On On AV Mute AV Mute
Select Select Mode Mode Source Source
Mouse Mouse RIGHT RIGHT LEFT LEFT RIight RIight Left Left
6
XP cClear10 English (good) 24-07-2003 15:52 Pagina 41