To enable VGA mode on the DX display controller, slide switch 1 on the DIP switch
into the ON position. Enable VGA on only one board when you install multiple
DX display controllers.

Disable VGA on all DX display controller if you are using a separate VGA card.

For single desktop mode, slide switch 3 into the ON position.

Warning

If you leave the computer turned
on, you could get an electric shock
and cause damage to the system
components.

Remove the DX display controller
slowly from its package and static-
shielding bag to prevent an
electrostatic discharge.

Static electricity can damage the
controller. When touching the board
or parts of the motherboard, take
these precautions:

•

Wear an antistatic wrist strap.

•

Discharge your body’s static

electricity repeatedly by
touching the power supply
or the metal surface of the
computer chassis.